WG9112340113 oil seal cross-reference checklist
The VKEFOT catalog lists WG9112340113 and WG9112340114 with a 190 x 220 x 15 mm TB NBR rear wheel hub seal. These are catalog references for identifying a candidate; fit must be confirmed for the actual assembly.
- Record the full marking and assembly reference.
- Compare dimensions, section and installation arrangement.
- Confirm the compound and duty against an approved drawing.
How to check the catalog candidate
The published product title identifies the reference numbers and TB structure; the product record lists NBR and dimensions of 190 mm inner diameter, 220 mm outer diameter and 15 mm height. Compare these fields with the original drawing, including any shoulders or additional dimensions.
Provide the vehicle and axle assembly reference, lubricant, speed, continuous and peak temperatures, pressure and contamination exposure. Request written confirmation of the proposed design before ordering.
Which documents should accompany the inquiry?
Send readable markings, photos of both faces and the side, the drawing revision and required quantity. General manuals explain selection considerations but do not certify this part or establish its operating limits. Original manufacturer names and references identify the application and do not imply authorization.
Published catalog fields and confirmation needed
| Field | Catalog record | Confirm before ordering |
|---|---|---|
| Reference numbers | WG9112340113 / WG9112340114 | Full marking and assembly drawing |
| Dimensions | 190 x 220 x 15 mm | Complete section and tolerances |
| Material / structure | NBR / TB | Compound grade and approved design |
| Operating limits | Not established by this comparison | Fluid, temperature, pressure and speed |
Catalog product record Source for the listed dimensions, material and reference numbers.
General rotary shaft seal technical manual General guidance; confirm the approved part drawing and compound data.
Updated
Request a quote · View the catalog-listed 190 x 220 x 15 mm seal
Need help specifying a seal?
Use these checks to prepare your enquiry. Final suitability depends on the specific design and operating conditions.
Check dimensions and design
Provide the shaft diameter, housing bore and seal width in mm. Include the part marking, lip profile or a dimensioned drawing if available.
Describe operating conditions
Share the fluid or medium, operating temperature, pressure and shaft speed. Confirm the material grade against the application.
Verify a replacement
Provide the original part number and photos. Similar dimensions alone do not confirm interchangeability; compare the design and material.
Selection questions
Does WG9112340113 alone guarantee interchangeability?
No. Use the catalog reference to identify a candidate, then confirm the complete drawing, compound and actual assembly.
What dimensions does the published candidate list?
The catalog record lists 190 mm inner diameter, 220 mm outer diameter and 15 mm height. Confirm the complete section and tolerances before ordering.
Where can I find the technical manual?
The Downloads page provides a general rotary shaft seal manual. It is selection guidance, not a part-specific drawing or approval.